Rain Patch

Rain Patch from Rubba-Roof

‘RAIN-PATCH’ SEALS LEAKS EVEN IN THE RAIN

REPAIRS CRACKS – HOLES – SPLITS – GAPS

100% WATERPROOF – CLEAR – CLEAN – SIMPLE

FOR EMERGENCY REPAIR – 24 HOUR DISPATCH! *

Only £49.95 inc VAT Buy Now!
Rubba-Roof Rain-Patch

Only £49.95 inc VAT Buy Now!

Rain-Patch is an emergency repair kit which will seal and stop leaks on just about any surface† giving an economical and effective waterproofing solution designed to last until a permanent reinstatement can be achieved.

The Rain-Patch kit contains all you need to repair up to 1m² of cracks, splits and holes. This new and improved formula can be applied in all weathers between -5°C and +50°C

IT CURES FAST!!   IT EVEN WORKS IN THE POURING RAIN.

Rain-Patch is clear and easy to apply – it is not a sticky black bitumastic substance.

What you get:-

1 x tin of Rain-Patch

1m² Reinforcing Fleece

1 x Disposable Brush

1 x 1 Pair of Gloves

1 x Applicator Squeegee

Instruction Leaflet

Only £49.95 inc VAT Buy Now!

Rubba-Roof Rain-Patch

Where to use Rain-Patch

Use Rain Patch to seal holes or leaks in any of the following situations:-

  • Leaks on flat roofs covered with felt, bitumen, asphalt, fibreglass, PVC.
  • Cracks in roof tiles or roof slates.
  • Splits in lead flashings around chimneys and valleys.
  • Failed joints in drainpipes and gutters.
  • Leaking concrete, brick or stone copings.
  • Edges around wooden door frames or window frames.
  • Weeping double glazing, plastic skylights and conservatories.
  • Broken corrugated roof sheets.

How to use Rain-Patch

Rain Patch from Rubba-Roof

Only £49.95 inc VAT Buy Now!

Rain Patch from Rubba-Roof
1. Using sharp scissors, cut the fleece patch to fit the area to be repaired. Allow a 4″/100mm overhang.

Rain Patch from Rubba-Roof
2. Apply a thick coat of Rain-Patch to the repair area, making it large enough to take the fleece patch. Use the brush or squeegee. Replace the lid.

Rain Patch from Rubba-Roof
3. Immediately press the fleece into the Rain-Patch and ensure a smooth fit with no air bubbles or gaps.

Rain Patch from Rubba-Roof
4. Wait a few minutes…
5. Apply a second coat of Rain-Patch over the entire area treated. Close the tin carefully.

Only £49.95 inc VAT Buy Now!

Rubba-Roof Rain-Patch

‘RAIN-PATCH’ SEALS LEAKS EVEN IN THE RAIN

REPAIRS CRACKS – HOLES – SPLITS – GAPS

100% WATERPROOF – CLEAR – CLEAN – SIMPLE

FOR EMERGENCY REPAIR – 24 HOUR DISPATCH! *

Only £49.95 inc VAT Buy Now!

Rain-PatchTech Specs

Physical PropertyTypical Test Result
AppearanceViscous Gel
Adhesion to most substratesExcellent
Slump or Sag (¼″ bead)None on vertical surfaces
Tack-free time30-60 minutes

Fully cured material
Adhesion:
Steel40 PLI
Glass50 PLI
Aluminium28 PLI
Concrete50 PLI
Wood50 PLI
Red Brick50 PLI
Tensile at 75°F (ASTM D-2370)600 psi
Elongation at 75°F (ASTM D-2370)800%
Recovery at 300%90%
PaintableYes
Fungus Resistance (Fed. T.M. STD No 6271)Passes

Benefits

  • Excellent Adhesion
  • Paintable No Primer Needed
  • Long-Term Service Life
  • Mildew and Fungus Resistant
  • Excellent Low-Temp Flexibility


  • Seals Damp Surfaces
  • Alkaline and Acid Stable
  • Resticks
  • Low Dirt Pick Up
  • Asphalt compatible


Caution

  • Not for use on Aquariums
  • Not for constant water submersion
  • Material must fully breathe to cure
  • Keep away from heat, sparks and open flame: contains toluol


  • Do not use in contact with solvents
  • Do not use where extreme abrasion is expected
  • Do not use on rubber membrane systems


Only £49.95 inc VAT Buy Now!

† NOTE: Rain-Patch is not designed for use on pipes carrying water under pressure (e.g. mains water, central heating systems etc.)
Rain-Patch may not be fully effective on latex rubber surfaces.
Rain Patch is Flammable. Do not smoke or use near any source of heat.
Do not use in unventilated confined spaces.
Make sure the area to be treated is clean and clear.